毕业论文

打赏
当前位置: 毕业论文 > 外文文献翻译 >

模具注塑成型英文文献和中文翻译(3)

时间:2018-06-09 20:53来源:毕业论文
2.2.1 Newtonian Fluids 17 2.2.2 Generalized Newtonian Fluids . 18 2.2.3 Linear Viscoelastic Models . 19 2.2.4 Viscoelastic Fluid Models 20 2.3 TimeTemperature Superposition 28 2.4 The PressureVolumeTe


2.2.1 Newtonian Fluids               17
2.2.2 Generalized Newtonian Fluids          . 18
2.2.3 Linear Viscoelastic Models           . 19
2.2.4 Viscoelastic Fluid Models            20
2.3 Time–Temperature Superposition            28
2.4 The Pressure–Volume–Temperature (PVT) Relation     . 32
2.5 Lubrication Approximation              . 33
3 Mold Filling and Post Filling  35
3.1 Hele-Shaw Equation                . 35
3.1.1 Flow in Thin Cavity of Arbitrary
In-plane Dimensions              353.1.2 Axisymmetric Flow in a Tube          . 41
3.2 Frozen Layer                  . 41
3.3 Mold Deformation                 . 42
3.4 Wall Slip                    . 44
4 Crystallization . 47
4.1 Introduction                   . 47
4.2 Crystallization Kinetics               . 48
4.2.1 The Kolmogoroff-Avrami Model         . 48
4.2.2 Growth Rate                49
4.2.3 Nuclei Number Density             51
4.2.4 Molecular Orientation             . 55
4.3 Effect of Crystallization on Physical Properties       . 56
4.3.1 Effect of Crystallization on Rheology        56
4.3.2 Effect of Crystallization on
Pressure–Volume–Temperature Relations      58
4.3.3 Effect of Crystallization on Thermal Conductivity   . 59
4.4 Influence of Colorants                60
4.5 Molecular Dynamics Simulation            . 63
5 Flow-Induced Alignment in Short-Fiber Reinforced Polymers  65
5.1 Concentration Regimes of Fiber Suspensions        65
5.2 Evolution Equations                66
5.2.1 Jeffery’s Orbit                66
5.2.2 Orientation Characterization           . 67
5.2.3 Fiber–Fiber Interactions             68
5.3 Closure Approximations               . 70
5.3.1 Linear Closure                70
5.3.2 Quadratic Closure               71
5.3.3 Hybrid Closure                71 模具注塑成型英文文献和中文翻译(3):http://www.youerw.com/fanyi/lunwen_17300.html
------分隔线----------------------------
推荐内容