毕业论文

打赏
当前位置: 毕业论文 > 电子通信 >

ADS的C波段微带线带通滤波器设计

时间:2021-10-24 10:45来源:毕业论文
介绍了微带滤波器的发展历程与研究现状;然后介绍了微带滤波器设计的理论基础与方法;最后根据设计指标,利用ADS仿真软件对平行耦合结构的微带带通滤波器进行了仿真优化设计

摘要滤波器是一个双端口网络,它拥有选频特征,允许需要频率成分的信号以最小的衰减通过,并大幅的衰减其它频率的信号。滤波器在现代电子通信系统中发挥着十分重要的作用,其性能直接影响着整个系统的性能。微带带通滤波器由于制作灵活、设计方便、体积小、易集成等优点,在射频集成电路(RFIC)和微波集成电路(MIC)中得到了大量的应用。   73262

本文首先介绍了微带滤波器的发展历程与研究现状;然后介绍了微带滤波器设计的理论基础与方法;最后根据设计指标,利用ADS仿真软件对平行耦合结构的微带带通滤波器进行了仿真优化设计。

毕业论文关键词  微带带通滤波器 ADS 平行耦合 

毕业设计说明书外文摘要

Title    The Design of Microstrip Bandpass Filter in C Band             

                                                                   

Abstract Filter is a dual port network which has frequency selective characteristics, allowing the required frequency components of the signal with minimal attenuation through, and a decay of other frequency signal。 Filter plays a very important role in modern electronic communication system, and its performance directly affects the performance of the whole system。 Microstrip bandpass filter is used in radio frequency integrated circuit (RFIC) and microwave integrated circuit (MIC) because of its flexible fabrication, convenient design, small size, and easy integration。

At first,this paper introduces the development and current states of microstrip filter,Then introduces the design theory and method。Finally, according to the design index, the ADS simulation software is used to simulate and optimize the parallel coupling  microstrip band-pass filter。

Keywords  microstrip bandpass filter   ADS   parallel coupling

目   次

1 引言 1

1。1  课题背景和意义 。。。1

1。2  微波滤波器发展历程与研究现状 1

2  带通滤波器设计理论 4

2。1  滤波器的分类 4

2。2  带通滤波器的主要参数 5

2。3  带通滤波器的设计原型 5

2。4  原型滤波器的元件值的归一化及其计算 7

2。5  微带线 8

3  带通滤波器的重要指标及优化原则 9

3。1  奇模和偶模特征阻抗 9

3。2  S参数 11

3。3  ADS介绍及优化原则 13

4  平行耦合带通滤波器的设计与优化 14

4。1  设计指标 14

4。2  原理图设计 14

4。2。1 低通滤波器原型的参数的计算 15

4。2。2 奇模和偶模特性阻抗的计算 16

4。2。3 微带线尺寸的计算 17

4。2。4 原理图的绘制 ADS的C波段微带线带通滤波器设计:http://www.youerw.com/tongxin/lunwen_83544.html

------分隔线----------------------------
推荐内容