毕业论文

打赏
当前位置: 毕业论文 > 材料科学 >

可调色温色度Eu3+NaY(MoWO4)2红粉的研究

时间:2019-03-23 21:48来源:毕业论文
通过高温固相法制备了Eu3+:NaY(MoO4)2红色荧光粉,并对其性能进行了研究。并通过 X 射线衍射仪以及荧光光谱仪的进行了相应的分析。经过XRD分析,其XRD峰位置和NaY(MoO4)2的标准PDF卡片J

摘要:本文通过高温固相法制备了Eu3+:NaY(MoO4)2红色荧光粉,并对其性能进行了研究。并通过 X 射线衍射仪以及荧光光谱仪的进行了相应的分析。经过XRD分析,其XRD峰位置和NaY(MoO4)2的标准PDF卡片JCPDS Card No.52-1802 完全一致。并得到了Eu 3+掺杂产物的发光性质在其掺杂浓度为30mol%时最强, 其有效激发波长是395nm,监控波长为615nm。其后又制备了Eu3+:NaY(Mo/WO4)2,钨的掺杂浓度分别为5mol%、10mol%、15mol%、20mol%,通过X射线衍射仪以及荧光光谱仪的进行了分析,得到其最佳掺杂浓度10mol%时,发光性能最佳,其有效激发波长是395nm,监控波长为615nm。通过色坐标对其分析,钨的掺杂在一定程度上改变了NaY(MoO4)2的色度及色温。33925
毕业论文关键词: NaY(MoO 4 ) 2  ;Eu3+ ;钨酸根离子掺杂; 固相法 ;钼酸盐
Influence of europium and won on the Luminescence Intensity of NaY(Mo1-xWxO 4 ) 2 Phosphors
Abstract :In this article, through high temperature solid state method the Eu3+: NaY (MoO4)2 red phosphors, and its performance are studied. And through the X-ray diffraction and fluorescence spectrometer has carried on the corresponding analysis. Through XRD analysis, the XRD peak position and NaY(MoO4)2 standard PDF CARDS JCPDS Card No. 52-1802.And the Eu3+ doped luminescence properties of the product in its strongest when doping concentration is 30mol%, the effective excitation wavelength is 395nm, monitoring wavelength of 615nm.Then the preparation of the Eu3+: NaY(Mo/WO4)2, tungsten doping concentration of 5mol% respectively,10mol%,15mol%,20mol%,by X-ray diffraction and fluorescence spectrometer was analyzed, and the optimal doping concentration for 10mol %, the luminous performance is the best, the effective excitation wavelength is 395nm, and monitor the wavelength of 615nm. Analysis by its color coordinates, tungsten doping in a certain extent changed the NaY(MoO4)2 of chromaticity and color temperature.
Keywords:  NaY(MoO4)2;Eu3+;Wo42- anionic group; Solid phase synthesis;molybdate
 目 录
第一章 绪论    1
1.1 引言    1
1.2 稀土荧光材料    2
1.2.1 稀土发光材料的特点    4
1.3 掺杂Eu3+钨/钼酸盐红色荧光粉的研究进展    5
1.3.1 稀土 Eu3+离子的发光特性    5
1.3.2 钼酸盐的结构和发光性质    6
1.3.3 掺杂Eu3+钨/钼酸盐红色荧光粉的研究进展    6
第二章 NaY(MoO4)2的详细制备过程与性能研究    8
2.1 高温固相法原理    8
2.2实验部分    9
2.2.1 试剂    9
2.2.2 仪器    9
2.3 实验方案    10
2.4 晶体结构    10
2.5 荧光性能    12
2.5.1  荧光粉的激发光谱    12
2.6 Eu3+掺杂浓度对荧光性能的影响    14
第三章 Eu3+:NaY(Mo1-xWxO4)2的制备过程、XRD分析及发光性能研究    15
3.1 Eu3+:NaY(Mo1-xWxO4)2的详细制备过程    15
3.1.1  Eu3+:NaY(Mo1-xWxO4)2的制备过程    15
3.2 Eu3+:NaY(Mo0.95W0.05O4)2、NaY(Mo0.9W0.1O4)2、NaY(Mo0.85W0.15O4)2、NaY(Mo0.8W0.2O4)2 的物相分析    16
3.3 Eu3+:NaY(Mo0.95W0.05O4)2、NaY(Mo0.9W0.1O4)2、NaY(Mo0.85W0.15O4)2、NaY(Mo0.8W0.2O4)2的光谱分析    17
3.4 色坐标分析    17
第四章 结论    20
致谢.21
参考文献..22
 
第一章 绪论
1.1 引言
荧光材料是由金属(锌、铬)硫化物或稀土氧化物与微量活性剂配合经煅烧而成。无色或浅白色,是在紫外光(200~400nm)照射下,依颜料中金属和活化剂种类、含量的不同,而呈现出各种颜色的可见光(400~800nm)。 可调色温色度Eu3+NaY(MoWO4)2红粉的研究:http://www.youerw.com/cailiao/lunwen_31249.html
------分隔线----------------------------
推荐内容